Advertisement
TOYOTA
Picture 31
38.
Take the two bottom extension brackets and
install them down behind the factory grille
shell onto the black metal bumper plate with
rectangular holes. The longer side of the
brackets base will install toward the center
of the vehicle and the upper arms will be
toward the outside of the vehicle (picture
32). The flange brackets will drop through
the rectangular holes and grab the lip on the
bottom of the rectangular hole when
secured. Tighten the screws on the flange
brackets to secure the brackets to the metal
bumper plate. Test fit the Billet in the
chrome shell opening to make sure the
holes in the bracket arms and the holes in
the mounting plates on the bottom back of
the Billet align correctly.
Picture 32
Southeast Toyota Distributors, LLC
TUNDRA
39.
Select
installing. For Limited & Platinum edition
use Logo (A), for SR & SR5 edition use
Logo (B). See diagram below (picture 33)
40.
Install the factory logo onto the logo plate,
the tabs on the back of the logo insert
through the holes in the front of the logo
plate. Insert the bottom tab first and then the
three top tabs, make sure the tabs latch on
the back of the logo plate (picture 34). Slide
the pvc tube down over the plastic latches
of the factory logo on the back of the logo
plate to secure the logo to the plate (picture
34A). Place the threaded studs on the logo
plate through the billet bars and the tabs on
the back of the Billet. Secure the plate with
two 10/32" nylon lock nuts.
Page 11 of 16
Billet Grille w/LED DRL
the
correct
logo
plate
Picture 33
Picture 34
before
Advertisement
