Datamax MP Compact4 Mark II Operator's Manual page 3

Copyright Information:
CG Triumvirate is a trademark of Agfa Corporation.
CG Times based upon Times New Roman under license from the Monotype Corporation.
Windows is a registered trademark of the Microsoft Corporation.
®
All other brand and product names are trademarks, service marks, registered trademarks, or registered
service marks of their respective companies.
Firmware (Software) Agreement
The enclosed Firmware (Software) resident in the Printer is owned by Licensor or its suppliers and is
licensed for used only on a single printer in the user's Trade or Business. The User agrees not to, and not
to authorize or permit any other person or party to, duplicate or copy the Firmware or the information
contained in the non-volatile or programmable memory. The firmware (Software) is protected by
applicable copyright laws and Licensor retains all rights not expressly granted. In no event will Licensor or
its suppliers be liable for any damages or loss, including direct, incidental, economic, special, or
consequential damages, arising out of the use or inability to use the Firmware (Software).
Information in this document is subject to change without notice and does not represent a commitment on
the part of Datamax-O'Neil Corporation. No part of this manual may be reproduced or transmitted in any
form or by any means, for any purpose other than the purchaser's personal use, without the expressed
written permission of Datamax-O'Neil Corporation.
Important Safety Instructions
This printer has been carefully designed to provide many years of safe, reliable performance. As with all
types of electrical equipment, however, there are a few basic precautions you should take to avoid hurting
yourself or damaging the equipment:
• Carefully read the provided installation and operating instructions.
• Read and follow all warning instruction labels on the printer.
• Place the printer on a flat, firm, solid surface.
• Make sure all openings on the printer remain unblocked; never insert anything into the openings or
ventilation slots.
• Do not place the printer near a heat source.
• Do not use your printer near water, or spill liquid into it.
• Be certain that your power source matches a listed voltage rating for the printer (if unsure, check with
your dealer or local utility company).
• Do not place the power cord where it can be stepped on; and, if the power cord becomes damaged,
immediately replace it.
• If service is required, use only qualified trained technicians to repair your printer.
All rights reserved.
© Copyright 2010 by Datamax-O'Neil Corporation
Part Number: 88-2351-02 Revision: A