Dometic ECOLINE RH418NTE Installation And Operating Manual page 18

Operation
I
NOTE
8
The red LED illuminates as soon as a signal has been sent out. Check the
batteries if the LED does not illuminate.
➤ Remove the plastic insulation from the battery holder before initial use.
➤ Align the upper side of the remote control to the LEDs of the interior light
(fig. 1 2, page 3). Maintain a distance of approx. 10 cm.
➤ Press the desired button:
Button
(fig. 2 page 3)
(2)
Black button
Yellow button
(4)
Blue button
6.4 Locking the door (optional)
➤ Turn the key a quarter turn to the left to lock the cooling device (fig. g, page 9).
6.5 Using the automatic door control (optional)
The automatic door control (optional) displays via an LED (fig. 1 3, page 3) that the
door has been opened.
If the door opening monitor LED is lit:
➤ Open the cooling device.
➤ If necessary, refill the cooling device.
➤ Reset the door control monitor with the remote control (optional).
– Hold the remote control towards the door opening sensor (fig. 1 1,
page 3).
– Press the red button once (fig. 2 1, page 3).
➤ Close the cooling device.
18
Inside temperature
Press once: Low level
Press twice: Lowest level (maxi-
mum performance)
(3) High level (minimum perfor-
mance)
Medium level
RH418NTE, RH418NTEG
LED signal
The LEDs of the interior light
flash at high speed.
The LEDs of the interior light
flash at low speed.
The LEDs of the interior light
flash at medium speed.
EN