Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro 75744 Operator's Manual

Adjusting the Height of Cut

Note:
The transport position is the highest
height-of-cut position or cutting height at 114 mm
(4-1/2 inches) as shown in
Height of cut is controlled by the lever located to the
right of the operating position
Figure 23
Figure 23.
(Figure 23).
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers to 1 of the following
positions:
•
Upper hole—use this position with the mower
deck in the 63 mm (2-1/2 inches) and below
the height-of-cut positions
•
Lower hole—use this position with the mower
deck in the 76 mm (3 inches) and above the
height-of-cut positions
g296586
1. Anti-scalp roller
2. Lower hole—the mower
deck in the 76 mm (3
inches) and above the
height-of-cut positions
3. Flange nut
21
ARK
(Figure 24).
(Figure 24).
Figure 24
4. Upper hole—the mower
deck in the 63 mm (2-1/2
inches) and below the
height-of-cut positions
5. Bolt
g019929