Table of Contents
Advertisement
Installation
Installation of Decoration Panel
The decoration panel has its installation
direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by
amount 10mm in length.)
The fixing screws (hexagon M5 screw) are included the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Piping side
Plasma filter
Louver motor
Decorative panel
Ratch
pull
CAUTION : Install
certainly the deco-
ration panel.
Cool air leakage
causes sweating.
Water drops fall.
10
Indoor Unit
) on the screws fixed in step above, and slide the panel so
Push
Inlet Grille
Inlet Grille
Inlet Grille
Good example
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel,
always remove the paper template.
Bad example
Air conditioner
unit
Cool air leakage
(no good)
Ceiling
board
Decorative panel
Decorative panel
fixing screws
(hexagon M6 screws)
Temporarily fitting
at 2 poles
(Tightening about 10mm)
Control box cover
Cover
Key holes
Decorative panel
fixing screws
(Hexagon M6 screw)
Air conditioner
unit
Decorative panel
Ceiling
board
Advertisement
Table of Contents
