Advertisement
Quick Links
Advertisement
Related Manuals for NCR 7649-K021
Summary of Contents for NCR 7649-K021
- Page 1 7649-K021 Extended I/O Daughter Card Kit Instructions Issue A...
-
Page 2: Revision Record
Revision Record Issue Date Remarks Nov 2011 First Issue... -
Page 3: Kit Contents
Introduction The Extended I/O Daughter Card provides three additional 12V Powered USB Ports for the 7649. Each port is capable of supplying 12V at 1.5A maximum each. Kit Contents Daughter Card Power Cable 497-0466589 Daughter Card USB Cable 497-0471686 Extended I/O Daughter Card 497-0466638 Extended I/O Daughter Card Bracket 497-467738... -
Page 4: Installation Procedures
Installation Procedures Warning: Disconnect the AC power cord before disassembling the Terminal. Caution: Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer’s case for a few seconds. Avoid any contact with internal parts and handle cards onlyby their external edges. - Page 5 b. Pivot the bottom of the cover out as shown to remove it. 30357 3. Disconnect all cables from the I/O Panel. Operator Disp DVI Operator Disp USB Printer USB WaveLAN USB UPS Power 30394...
- Page 6 4. Loosen the Thumbscrew on the Elextronics Box. 5. Grasp the sheet metal extension on the Electronics Box and slide the assembly out of the chassis. Sheet Metal Extension Thumbscrew 30500 6. Remove the screw that secures the Electronics Box Top. Electronics Box Top 30501...
- Page 7 7. Slide the top slightly toward the end of the unit as shown and then lift it up to remove it from the Electronics Chassis. 30502 8. Remove the knock-out from the Back Panel with a flat-blade screwdriver. Knock-Out 30592...
- Page 8 9. Temporarily remove the RAID Card so the Extended I/O Daughter Card Power Harness can be connected to the Motherboard. Note: The RAID/Riser Card is an optional feature and may not be present. a. Disconnect the RAID SATA Cables. b. Remove the screws (2) that secure the RAID Card to the bracket. Screws SATA Cables 30504...
- Page 9 10. Plug the Extended I/O Daughter Card Power Harness into the Motherboard. Extended I/O Daughter Card Power Harness 30593 11. Install the Extended I/O Daughter Card in the Back Panel (2 screws) and connect the Power Harness. Extended I/O Daughter Card 30594...
- Page 10 12. Remove the existing USB Cable from the Motherboard (Header) and Back Panel (2 screws). USB Cable 30595...
- Page 11 13. Install the new USB Cable to the Extended I/O Card, Motherboard (Header), and Back Panel (2 screws). USB Cable 30596 14. Reinstall the RAID Card (if applicable). 15. Replace the Electronics Box Top Cover. 16. Install the Electronics Box in the terminal. 17.