Introduction The Extended I/O Card provides three additional 12V Powered USB Ports for the 7600/7601. Each port is capable of supplying 12V at 1.5A maximum each. Kit Contents...
Installation Procedure Warning: Disconnect the AC power cord before disassembling the Terminal. Caution: Static Electricity Discharge may permanently damage your system. Discharge any static electricity build up in your body by touching your computer’s case for a few seconds. Avoid any contact with internal parts and handle cards only by their external edges.
Page 5
5. Plug the Daughter Card Power Cable into the Motherboard. Daughter Card Power Cable 29517 6. Install the Extended I/O Daughter Card to the I/O Panel (2 screws) and Tie Wrap Holder. 29510 Extended I/O Daughter Card Tie Wrap Holder...
Page 6
7. Connect the new USB Cable to the Motherboard, Front Panel Board, and Daughter Card Daughter Card Power Cable USB Cable Connectors 29512 Note: The Tie Wrap Holder is used to secure the PS/2 Cable with a Tie Wrap. Tie Wrap Holder Tie Wrap...