LG TD-H803CSW Owner's Manual page 14

EN 14 INSTALLATION
Installation Procedure
WARNING
• For safety reasons, installation procedure should
be performed by two or more qualified service
personnel.
• The weight of the appliance and the height of the
installation makes the installation procedure too
risky for one person.
• Incorrect installation can cause serious
accidents.
• Do not operate if the appliance is not properly
stacked.
1
Place the appliance on the top of an LG front
load washing machine.
2
Remove the 2 screws from the bottom of the
rear cover on each side.
3
Align the LG stacking kit holes and the rear
cover holes in a line.
• In case of the top plate size is 600 mm
• In case of the top plate size is 550 mm
4
Fasten the 2 screws that were removed earlier
from the appliance to the stacking kit.
5
Use the 4 screws in the accessory box (16 mm)
to assemble the washing machine rear cover
and stacking kit.
6
The procedure for the opposite side will be the
same.
Installing the Optional Drain
Hose
Normally, condensed water is pumped up to the
water collection tank where water is collected until
manually emptied. Water can also be drained out
directly to a mains drain, especially when the
appliance is stacked on top of a washing machine.
With the connecting elbow or T piece of the mains
drain hose, simply change the water path and re-
route to the drainage facility as below:
1
Separate the anti-backflow lid
collection tank hose
elbow or T piece.
2
Attach the anti-backflow lid
the connecting elbow or T piece and then
connect the optional drain hose
opposite side of the connecting elbow or T
piece.
CAUTION
• If the optional drain hose is installed in a way
that leaves it bent or pinched, drainage may not
function properly.
and the water
a
from the connecting
b
b
a
to the head of
a
to the
c
a
c