Page 1
(inch) Important Information - This manual is designed to help you to install, operate and maintain the PC-S43 Paper Cutter. Please read and understand this manual and keep it in a safe and convenient place. - Do not operate the PC-S43 until you read and understand the instructions in this manual.
Page 2
Safety Precautions - The term WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. - The term CAUTION indicates a potentially hazardous situation which, if not avoided, may result in damage to the machine. It may also be used to alert against unsafe practices. - Please read and understand all safety instructions which include the terms WARNING and CAUTION.
Machine Safety Features This machine has been designed with safety in mind. Please understand these fea- tures, and use them when operating the machine. Knife is Locked. The machine is protected The machine includes a When this door is open, by covers which prevent key switch.
Contents Important Information ............... I Safety Precautions ................II Machine Safety Features................ III Machine Description ............1 Machine Features ............. 3 Operating Procedures ............. 5 Troubleshooting ............... 9 1 The last few sheets are not cut............. 9 2 The machine will not cut ............... 9 3 If the "Problem inside the machine"...
Machine Description This section includes a description of the machine. Monitor Knife Holder Ready This holder is attached to the knife by six screws. Cutting Knife Problem inside machine Clamp Safety cover open This clamps the sheets to prevent them from moving Door open during cutting.
Machine Features This section explains the machine features. These LED's can be used to The knife can be replaced check the machine opera- easily because it is dispos- tion. See page 1. able. See page 12. The illuminated cut line Use this lever to move the conveniently indicates the cut sheets forward for easy...
Operating Procedures This section explains how to operate the machine. Turn on the power switch. Set the back-gauge to the cutting length. Rear View The back-gauge can be moved forward or back using the adjusting knob. Use the scale to set the back-gauge.
Page 10
Operating Procedures Dispose of the trim. Close the safety cover. If the cover remains open, the machine will not WARNING run. If some trim is stuck to the knife, remove it using a brush Once the cover is closed, the LED will to prevent your hands or go out.
Page 11
Operating Procedures Close the safety cover. Turn off the key switch. Turn the key switch to the left and remove it. Only authorized persons should have access to the key.
Troubleshooting This section lists some possible solutions if the cutting quality is not satisfactory, or there is a problem with the machine operation. The last few sheets are not cut Problem Solution See Page The cut stick is worn. Replace the cut stick. The edge of the knife is worn.
If the "Problem inside the machine" LED is lit and the buzzer sounds. Problem Solution There is a problem inside the machine. Attempt to reset using this procedure: Turn off the key switch. Wait for one minute. ( Problem inside machine ) Turn on the keyswitch.
Replacing Wearing Parts This section explains how to maintain the PC-S43 to keep it in good condition. Replacing the Cut Stick When the groove in the cut stick gets too deep, the last few sheets may not be cut, or may not separate completely.
Appendix This section lists the accessories and wearing parts, and includes an index. Accessories Key (4015793-00) Set of 2 Knife Sheath 1 pc 0.12" Allen Wrench (4015790-00) 1 pc Power Cord 1 pc 115V: 4009882-00 (14)