Installation Of Your Classic Preamp; Choosing A Location; Powering The Classic Preamp; Connection To The Mains - Nagra CLASSIC PREAMP Owner's Manual

INSTALLATION OF YOUR CLASSIC PREAMP

__________________________________________________________

Choosing a location

The CLASSIC PREAMP is designed for indoor use exclusively.
The CLASSIC PREAMP must be installed horizontally on a flat, firm
and stable stand. Take care that the ventilation slots in the bottom
are unobstructed and allow enough clearance above the unit.
We recommend you to ask your Nagra dealer for a demonstration
of the VFS-L isolation base that offers a perfect match for your
Nagra CLASSIC PREAMP.

Powering the CLASSIC PREAMP

The CLASSIC PREAMP can be powered:
- either with its own internal power supply and the provided AC
power cord
- or with an external Nagra MPS power supply

Connection to the mains

Push the mains power switch at the back of
the unit into the 0 (OFF) position. Insert the
power cord into the IEC connector of the
CLASSIC PREAMP.
You may then push the mains power switch
into the 1 position (ON).

Fuse replacement

The fuse holder includes a replacement fuse.
The fuse type is
FST 5x20mm 250V / T 500mA L.
Should you need to replace it, only use the
same fuse type.
30
NAGRA – CLASSIC PREAMP