"Lock-On" Button - Bosch ROS65VC Operating/Safety Instructions Manual

2610051956.qxp_ROS65VC 8/16/18 1:54 PM Page 11
FIG. 9
TRIGGER "ON-OFF" SWITCH
To turn the tool "ON" squeeze the trigger
switch. To turn the tool "OFF", release the
trigger switch, which is spring loaded and will
return to the "OFF" position automatically
(Fig. 1).
See START OF SANDING on page 12

"LOCK-ON" BUTTON

The "Lock-ON" button, located near the trigger
allows for continuous operation at maximum
OPM without holding the trigger (Fig. 1).
TO LOCK TRIGGER "ON": squeeze trigger,
depress button and release trigger.
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
depressed, the trigger can not be released.
VARIABLE SPEED WITH DIAL SETTING
Your sander is also equipped with a variable
speed dial (Fig. 1). The sander's orbital pad
speed can be preset from zero to maximum
nameplate OPM by rotating the dial in the
VX120
DUST
PORT
Operating Instructions
If the "Lock-ON" button is
continuously being
SERIES HOSE
BOSCH VAC-
SERIES HOSE
VAC024
SUCTION CONTROL
SLOT
housing. The dial may be set on or between
any of six positions (1=low through 6=high).
The following table may be used as a general
guide for abrasive and backing pad selection,
but the best results will be obtained by sanding
a test sample of the workpiece first.
Switch
Material setting
rough/finish
woods:
softwoods 4 / 6
hardwoods 4 / 6
veneers 4
metals:
steel 4
stainless 4
aluminum 4/ 6
rust spots 6
paintwork:
sanding 2 / 3
scratches 4 / 6
stripping 4
-11-
BOSCH VH-
1-1/4"
OR
1-1/2" HOSE
Backing Grit
pad size
rough/finish
extra soft 60 / 240
soft 60 / 180
soft 240 / 320
soft 60 / 240
soft 120 / 240
soft 80 / 240
extra soft 60 / 120
soft 180 / 400
hard 120 / 240
soft 40/60 /80