Remote Control Transmitters; Transmitter Operation - Silencer 30SL User Manual

REMOTE CONTROL TRANSMITTERS

CHANGING THE BATTERY IN YOUR TRANSMITTERS
SLRF434: The transmitter uses one (1) 3-volt lithium ion battery (#CR2032) with the (+) side facing upward.
To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower
right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top
case from the bottom case. It should snap apart after breaking the seal. Before removing the battery note the
direction of the positive (+) terminal. Place the new battery in exactly the same manner, being careful not to
bend or damage the contact terminal. Snap the cases back together and then test the transmitter to insure it
arms and disarms the alarm.
SLRF434 Transmitter Battery Replacement
CR2032
+Side DOWN
OPERATION

TRANSMITTER OPERATION

Transmitter Button
Button
– Button
Button
Button for 3 Seconds
Button
– Button
Button for 3 Seconds
+ Button
+
Button for 1 Seconds
+
UM-FULL-30SL rev A
System Function
Lock Door / ARM
Arm and Delete
Optional Sensor
Car Locator
Panic Function
Unlock Door / DISARM
Two Steps Door Unlock &
Disarm System
Pop Trunk Release
Silent LOCK / UNLOCK
Activate Car-Jacking
(OPTIONAL)
SILENT LOCK / UNLOCK or CH4
Switching Code for
2nd Car Operation.
2
Remark
ARM (OPTIONAL)
Press Twice (OPTIONAL)
While System Armed
Press 3 Seconds
Press Twice within 3 Seconds.
(Optional Installation and
Programming Required)
Press 3 Seconds
Ignition in "OFF" Position.
Ignition in "ON" Position.
Must be Programmed to Use as CH4.
Press and hold until TX LED is "ON"