Technical Specifications - STEINEL IS 3180 Installation Instructions Manual

BDAL_IS3180_24spr_neu
Manual override function
If a mains switch is installed in the mains supply
lead, the light is capable of the following func-
tions in addition to the simple ON/OFF function:
2 x aus/an
1 x OFF/ON
5 sec. – 15 min. 4 Stunden
2 x aus/an
2 x OFF/ON
4 Stunden

Technical specifications

IS 3180
Dimensions:
Output:
Mains power:
Recom. mounting height: 2 m
Angle of coverage: 180° horizontally
90° vertically
Reaches: –
Basic setting 1: 4 – 8 m max.
Basic setting 2: 8 – 20 m max.
Detection levels: 7
Switching zones: 448
Twilight setting: 2 – 2000 lux
Time setting: 5 sec. – 15 min.
Manual override: selectable (4 h)
Enclosure: IP 54
25.07.2008 15:09 Uhr
Important: The switch should be actuated in
rapid succession (in the 0.5 – 1 sec. range).
Sensor operation
1) Switch light ON (when light is OFF):
Turn switch OFF and ON once.
Light stays on for the period selected.
2) Switch light OFF (when light is ON):
Turn switch OFF and ON once.
The light goes out or switches over to sensor
mode.
Manual override
1) Select manual override :
Turn switch OFF and ON twice. The lamp is
set to stay on for 4 hours (red LED lights up
behind the lens). Then it returns automatically
to sensor mode (red LED off).
2) Deactivate manual override:
Turn switch OFF and ON once. The light goes
4 hours
out or switches over to sensor mode.
IS 3360
(l x w x h) 95 x 95 x 65 mm
• 2000 W max., VDE tested
(resistive load, e.g. filament bulb)
• 10 AX max., VDE tested (fluorescent tube)
• 900 W max. (series corrected)
• 500 W max. (parallel corrected,
at C = 45.6 µF
• 600 W max. (electronic ballasts, capacitive,
e.g. low-energy lamps, 8 each max.)
230 – 240 V, 50 Hz
2.5 m
360° horizontally
180° vertically
20 m max. all-round
–
–
10
1416
2 – 2000 lux
5 sec. – 15 min.
selectable (4 h)
IP 54
17
Seite 18
IS 345
3 m
12 x 4 m radially
20 x 4 m tangentially
20 x 4 m max.
–
–
5
280
2 – 2000 lux
5 sec. – 15 min.
selectable (4 h)
IP 54