Set Button and
Charging
Indicators
5.
Remove the Battery from the Charger Adapter when it is fully charged.
6.
Press and hold the TEST button of the Battery. Read the Battery Display on the end of
the Battery. The (far-right) light should display green for full.
Note: The operation time of a new battery will ramp up as it is properly used (drained) and
recharged. It will take about five recharging cycles before the Battery is at maximum effi-
ciency.
Caution: If two or more batteries are to be charged, avoid damaging the Charger Adapter
by allowing it to cool down between charges. Wait for the Battery to cool down before
placing in the tool.
Caution: Before cutting or trimming, run the tool for about 10 seconds to ensure that all
moving parts are running smoothly, and there are no loose parts, rattles, or sparking
that would indicate damage. Be sure the bit is firmly and properly installed before use.
Improperly installed bits may eject suddenly at high speed from the tool.
On / Off Switch (26)
SKU 92879
Battery (36)
Battery Power Display
Charger
Adapter (38)
Battery Test Button
OPERATING INSTRUCTIONS
Controls and Indicators
Height Adjust Knobs (9)
Body Handle
Side Handle
For technical questions, please call 1-800-444-3353
Wheel Screw (8)
Wheel (1)
Pivot Screw (6)
Collet Nut (14)
Spindle Lock (22)
Button
Circle Cutter Jig
Ball Handle (5)
Ruler (2)
Page 7