Toshiba W-707 Owner's Manual page 39

Buttons to control a remote-
controllable DSS ® satellite receiver
Once you complete the set-up for a remote
controllable DSS ® satellite receiver, your DSS
satellite receiver can be controlled by the
following buttons on the remote control of the
VCR.
• POWER (CABLE BOX)
®
To turn the DSS satellite receiver on or off.
• CH (CABLE BOX)
To select satellite channels in the upper or
lower direction. (not applicable to some brands
®
of DSS satellite receiver.)
• Number buttons (0 – 9)
To select desired channels to record.
OFF: if your DSS ®
controllable.
• Satellite channels will be selected by
the own channel selector of the DSS
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
receiver.
Go to step 8.
7
Select "BRAND TYPE" using CURSOR DOWN , and enter a
brand code of your DSS
buttons . Refer to the table on the next page.
Example: For a TOSHIBA DSS
number 99.
PROGRAM SET UP
n
USE
OUT UT CH P
n
O
CO T O R L
n
BRA D T YPE
n
E D: PROG
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG. to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
receiver will not be able to change channels in the timer recording. In this
case, set "CONTROL" to "OFF" in step 6.
3 ®
• The VCR Plus+ C system recording is not available on satellite channels.
®
• The DSS satellite receiver control is not compatible with the cable box
control.
Table of DSS
codes
®
satellite receiver is NON remote-
®
USE
OUT UT CH
CO
® satellite
n
E D:
® satellite receiver using number
®
satellite receiver, identified by
PRESET
VCR display
O C . BOX D S S
3 C H
n
FF O
n
O . 9 9
® satellite receiver brand
Brand name of your
®
DSS satellite receiver
TOSHIBA
RCA
SONY
PROGRAM SET UP PRESET
n
O C . BOX D S S
P 3 C H
n
n
O FF O
T O R L
PROG
®
® satetllite
Brand code
99
98
97
39