Basic Recording - Toshiba RD-XV48DTKF Owner's Manual

E3NG0FD_EN.book Page 43 Wednesday, January 30, 2008 10:37 AM

Basic Recording

Video
HDD HDD
D D VD-R DVD-RW VD-RW W
D D VD+R DVD+RW VD+RW W D D VD+R DVD+R VD+R
Follow the steps below to record a TV programme.
(See page 93 for VHS recording.)
1
Press [B ON\STANDBY] to turn on
the unit.
Turn on the TV and be sure to select the input to
which the unit is connected.
If you are recording to the HDD, press [HDD],
then proceed to step
If you are recording to a disc, press [DVD].
2
Press [OPEN\CLOSE A] to open the
disc tray.
3
Place the disc on the disc tray with
its label facing up. Be sure to align
the disc with the disc tray guide.
4
Press [OPEN\CLOSE A] to close the
disc tray.
5
Select the recording mode using
[REC MODE]. (See page 37.)
6
Press [INPUT SELECT F] to select
DVB, analogue or external input
mode, then select the desired
channel to record using
[PROG. G \ H] or
[the Number buttons].
7
Press [REC I] to start recording.
The "I HDD" or "I DVD" mark will be displayed
on the TV screen briefly.
To pause the recording, press [PAUSE F]. Press
[PAUSE F] or [REC I] again to restart the
recording.
8
Press [STOP C] to stop the
recording.
This operation may take a few moments to
complete.
VR
DVD-RW DVD-RW DVD-R DVD-R
5
.
Disc tray guide
Hint
• You can change the channel while in the REC pause
mode.
Note
• Recording starts immediately and continues until the
disc is full or you stop recording.
• You cannot change the recording mode in the REC
or REC pause mode.
• Even if the broadcasting you are recording is in the
SECAM system, this unit automatically converts it to
the PAL system when recording.
• If the external equipment is connected to AV2, the
picture of the external equipment will be output
except during the DVD playback of this unit. Turn off
the external equipment or press [DISPLAY] to
output the picture of this unit.
• You can play back a title on one component while
making a recording on the other component. To do
so, simply select the component (HDD or DVD) you
want to use for the playback by pressing [HDD] or
[DVD] during HDD / DVD recording. And then follow
the normal playback procedure.
• If playback and recording are in progress at the
same time, select the appropriate component by
pressing [HDD] or [DVD] before you press
[PAUSE F] or [STOP C] to pause or stop the
operation.
• NTSC recording is prohibited in this unit.
43
EN