Table of Contents
Advertisement
Connecting to an optional equipment with S-video output
If you connect a VCR with an S-VIDEO cable to the S-VIDEO IN jack on the rear lower left of the TV/DVD, you
must also connect the audio cables to the AUDIO IN jacks on the rear lower left of the TV/DVD (LINE 1 IN). The
S-VIDEO cable only carries the video signal. The audio signal is separate.
Note: When the S-VIDEO cable and the standard video cable are connected at the same time, the S-video cable takes precedence.
Ex. VCR with S-Video
To S-VIDEO OUT
Connecting an optional equipment with ColorStream
Your TV/DVD is capable of using ColorStream
video compatible DVD player, such as a Toshiba DVD player with ColorStream
quality and performance.
Ex. DVD player with Component video
To Component
Video OUT
Selecting Component input mode
Press INPUT SELECT repeatedly to
select "COMPONENT" mode.
®
The ColorStream
inputs on this unit are for use with devices that output 480i interlaced signals and 480p progressive signals. This
unit will not accept or display 720p progressive scan signals or 1080i interlaced high-definition signals. If you connect a high-
definition set-top receiver, 720p progressive scan DVD player, or other similar device to the unit's ColorStream
SWITCH THE DEVICE'S OUTPUT TO 480i INTERLACED OR 480p PROGRESSIVE MODE FIRST. Failure to do this will cause a
poor or no picture to display.
Notes:
• Refer to the owner's manual of the connected equipment as well.
• When you connect the unit to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet
before making any connections.
• If you place the unit near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the unit away from the
tuner and radio.
J5N00201A [E] (P14-25)
To Audio (L/R) OUT
Audio cable (not supplied)
S-Video cable (not supplied)
®
(component video). Connecting your TV/DVD to a component
To Audio OUT
Audio cable (not supplied)
Component video cable (not supplied)
When using the Component video cable,
an Audio cable must be connected to
AUDIO IN (L/R) (LINE 1 IN) jacks.
COMPONENT
17
Rear lower left of TV/DVD
To AUDIO (L/R) IN
To S-VIDEO IN
®
(Component video) output
®
can greatly enhance picture
Rear lower left of TV/DVD
To AUDIO (L/R) IN
6/8/04, 7:01 PM
To COMPONENT
(Y, P
/C
, P
/C
) IN
B
R
B
R
®
inputs, YOU MUST
17
Advertisement
Table of Contents
