Advertisement
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
18
J8504691
19
J3904768
© Volvo Car Corporation
Remove the three clips (1) that hold the right-hand side panel in
the bodywork.
Unhook the side panel from the mounting (2) on the underneath
of the parcel shelf.
Fold out the rear edge of the side panel from the bodywork. At
the same time unhook the side panel from the rear load securing
eyelet. If the car has a 12V socket in the side panel, disconnect
the connector from this socket (if applicable).
Fold out the side panel to access the space in the rear of the
wheel arch.
Applies to cars with reversing warning systems
Remove the back-up (reversing) warning system (PAS) from
behind the right-hand wheel arch, to facilitate access to route the
cable harness to the tow bar. If necessary, disconnect any
surrounding wiring.
Installing the trailer hitch connector, applies to the S40 (04-)
and V50
Towbar, wiring, 13-pin- 31346062 - V1.2
Page 12 / 22
Advertisement
