Blaupunkt NASHVILLE DAB47 Operating Instructions Manual page 42

SD/MMC mode
Starting recording
To record a DAB programme onto an SD/
MMC,
u
switch to DAB mode and select the pro-
gramme that you want to record. For
further details on this, please read the
"DAB mode" chapter.
u Press the REC•DEL button 9 when
you want to start recording.
Notes:
• You cannot start recording during
the fi rst 15 seconds after switching
to DAB mode or after switching on
the radio with DAB mode activated.
This also applies if you pressed the
REC•DEL button 9 and the display
shows "RECORDING".
• To avoid damaging the SD/MMC, you
should never start the engine whilst
recording. Starting the engine might
cause the voltage of the vehicle's
electrical system to drop, which could
permanently damage the SD/MMC.
• The automatic DAB-FM switching fea-
ture is deactivated whilst recording is
taking place. The DAB programme re-
mains tuned during recording, even if
the reception quality deteriorates.
Recording starts and "RECORDING" ap-
pears on the display for approx. 2 seconds.
If there is insuffi cient space available on the
card, "CARD FULL" appears on the display
for approx. 2 seconds. In this case, delete
items from the SD/MMC (see "Deleting re-
cordings" following below) or insert a dif-
ferent SD/MMC.
The fi le created during recording is given
a name as follows:
98
ddhhmmss.mp3. "dd" stands for the day
the recording was made, "hh" stands for the
hour recording was started, "mm" stands
for minutes and "ss" for seconds.
The device creates the "DAB_DIR" direc-
tory on the SD/MMC to store the recorded
fi les.
Telephone/navigation during recording
Telephone calls or voice output from a navi-
gation system do not affect recording. The
DAB programme continues to be recorded
in the background during a telephone call or
voice output.
Stopping recording
If you want to stop recording,
briefl y press the REC•DEL button 9.
u
"RECORDING STOPPED" appears on the
display for approx. two seconds.
Recording is stopped automatically in the
following cases:
• If the storage space on the SD/MMC
fi lls completely during recording. In
this case, "CARD FULL" appears on the
display.
• If you switch programmes during the
recording.
• If a problem arises with communica-
tions between the SD/MMC and the
device, you will see "MMC ERROR" ap-
pear on the display and recording is
then stopped.
• If you deactivate DAB mode whilst re-
cording, e.g. by switching to CD mode
or radio mode.