Connection; Turning The Power On And Off - Toshiba TDP-D1 Owner's Manual

Connection

Before connection
• Read the owner's manual of the device to be connected to the projector.
• Some types of computer cannot be used connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connection.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Computer DVD player
To Y/C /C output
B R
Green (Y), Blue (C ),
B
Red (C )
R
Conversion
adapter
BNC-pin
(not supplied)
To audio
To RGB
output
output
To USB
Monitor cable
port
Mini D-sub 15P-BNC
(not supplied)
p.30
RGB cable
(supplied)
Audio cable
USB cable
(for computer)
(supplied)
(supplied)
To audio
input
White (L)
Red (R)
CRT monitor, etc. Audio system, etc.
Note
• The AUDIO IN terminal is common among all the devices for input terminal.
• On the AUDIO OUT terminal, L and R mixture audio signal (monaural) that volume is
adjusted by a projector is output.
• When a plug is inserted to the AUDIO OUT terminal, the projector's speaker outputs no
sound.
p.36 , etc.
VCR
To audio
To audio
To S-Video
output
output
output
White (L)
White (L)
Red (R)
Red (R)
Audio cable
Yellow
(supplied)
(to video output)
S-Video cable
Video cable
(not supplied)
(supplied)
AUDIO IN VIDEO S-VIDEO
AUDIO OUT USB CONTROL
Control cable
p.38
To RS-232C
terminal
Computer (for control)
18

Turning the power on and off

I Connecting the power cord
1
Insert the power cord connector into the
AC IN socket of the projector.
2
Insert the power cord plug into a wall or
other power outlet.
I Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
I Turning the power on
1
Turn on the main power switch
Then, following three green indicators
will come on for several seconds: ON,
TEMP, and LAMP. Next, the ON
indicator will change to orange,
indicating standby mode.
2
Press the ON/STANDBY
button.
The power turns on, and the following
3 green indicators light: ON, LAMP,
and FAN. After a moment, the start-up
screen appears.
CAUTION
• Do not look into the lens during operation. Doing so could damage your vision.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal
overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could
cause burns, deform/break the object.
O
S-V IDE
VID EO
IN
AU DIO
RO L
CO NT
US B
OU T
AU DIO
(Supplied) Power cord connector
AUDIO IN VIDEO S-VIDEO
ON LAMP TEMP
AUDIO OUT USB CONTROL
(Green) (Green) (Green)
ON LAMP TEMP
(Orange) (Off) (Off)
Remote
Control panel Control
Start-up screen
ON LAMP TEMP FAN
ON/STANDBY LASER
CALL
ON/STANDBY INPUT
MUTE FREEZE
AUTO AUTO
KEYSTONE SET
MENU
PAGE PAGE
DOWN UP
- +
VOL. VOL.
AUTO KEYSTONE AUTO SET
19
FAN
(Off)
FAN
(Off)