Preparing And Using The Remote Control - Toshiba TDP TDP-T9 Owner's Manual

Preparing and using the remote control

■ Loading dry-cell batteries
into the remote control
 Remove the battery cover.
 Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (LR03, SIZE AAA) are
used.
 Replace the battery cover.
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries with
new ones.
The remote control
• Turn off the ON/OFF switch of the remote control when not in use or to store in baggage.
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
■ Operating the remote
control
Turn on the ON/OFF switch of the
remote control.
Point toward the projector's
infrared remote sensor, and press a
button on the remote control.
• Operating the projector from the front
20
Approx. 15