Toshiba B-570 SERIES Owner's Manual page 81

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
7. Install the cutter unit with the attached screws (cutter attaching screw, FL-4x6).
When installing the cutter, make sure that the cutter guide is not in contact with the platen. If it is, print
failure or noise may be caused.
8. Remove the motor cover. (See Fig. 2-9.)
9. Disconnect the connector from CN2 on the PWM PC board.
Clamp and pass the cable through the opening and connect it to the CN1 on the Cutter I/F PC board.
CPU PC Board
Clamp
Cable
PWM PC Board
Connector (CN2)
Connector (CN2)
3-4
SVO7A1003: Nov. 21 '97
3.2 CUTTER MODULE (B-4205-QM)
Fig. 3-5
Opening
Cutter Unit
Cut I/F PC Board
Fig. 3-6
EM18-33010A