Baofeng UV-5RV2+ Operating Manual page 27

In most dispatch environments it is common to have a system that allows radios to automatically
identify themselves to the dispatcher. This is known as Automatic Number Identification (AIN), or PTTID,
due to the radio sending a data burst containing the ID code at the beginning or end of a transmission.
This device does DTMF signaling to enable ANI implementation.
Procedure: Setting ANI/PTT-ID Code
1. Attach the radio to the computer and open the Baofeng PC software. See the "Computer
Programming" for more details on the PC Software.
2. In the Edit menu, select DTMF to open up the DTMF Encode/Decode.
3. Go to the Program menu, select Read from Radio to open the Read from Radio window.
4. Click the Read button. The status LED on the radio will flash red indicating the transmission of
data.
5. Locate the box name ANI Code and enter any relevant ANI code details into the text field.
a. If group ID codes are used instead of personnel ID codes, it is possible to enter up to 15 of
them in the list on the left in the DTMF Encode/Decode window. These can be assigned
on a channel by channel basis in the Channel Information field.
6. Check the Press PTT to Send box to transmit ID prior to regular transmission.
7. Check the Release PTT to Send box to transmit ID after regular transmission.
8. In the Program menu, select Write to Radio and the Write Data to Radio window will open.
9. Click the Write button. The status LED on the radio will flash green indicating that it is receiving
data.
To fully enable ANI settings, there are a few more steps. The directions below assume that the radio is
still connected to the PC and that the software is running.
Procedure: Enabling/Disabling/Configuring ANI Settings
1. In the Edit menu, select Optional Features. This will open a window called Optional Features.
2. Go to the Program menu, select Read from Radio and the Read from Radio window will open.
3. Click the Read button. The status LED on the radio will flash red indicating the transmission of
data.
4. Use the PTT-ID drop-down list to select the position of both the ANI data burst; BOT (Beginning
of Transmission), EOT (End of Transmission), or BOTH. To turn ANI off completely, select OFF
from the drop-down list.
5. In the Program menu, select Write to Radio and the Write Data to Radio window will open.
6. Click the Write button. The status LED on the radio will flash green indicating that it is receiving
data.
*After these two procedures have been completed, the radio should be completely set to ANI.
http://baofengradio.us 27