Cursor Movement Keys - IBM 6360 Product Support Manual

6. CHG FMT (Change Format). Causes a
Format Selection Menu to display
during the Create or Revise Docu-
ment task permitting the operator
to make format changes.
7. INSTR (Instruction). Causes the
Instruction Menu to display, per-
mitting the operator to put an
instruction in text.
8. GET (Single Diskette Unit).
Copies a page from a document on
the work diskette in use and puts
it in at the cursor position in
the currently displaying document.
GET (Dual Diskette Unit). Copies
a page from a document on any work
diskette and puts it in at the
cursor position in the currently
displaying document.
9. PAGE END. Inserts a temporary
page end into a document. Pagi-
nation may move this page end if
necessary.
10. REQD (Required Page End). Inserts
a page end into a document. Pagi-
nation wll not move this page end.
A page will always end at this
point.
6 7 8 9 10
Figure 2-6. Function Control
(Group 3)
Keys
Cursor Movement Keys
1.
t
(Cursor Up). Moves the cursor
up one line.
2 .
~
(Boundary Up) . Moves the
cursor to the first character of
the page being displayed.
3.
~
(Cursor Down). Moves the cur-
'sor down one line.
4.
K'"
(Boundary Down). Moves the
cursor to the page end code on the
page being displayed.
5.
+-
(Cursor Left). Moves the cur-
sor to the left one character
position.
6 .
~
(Boundary Left). Moves the
cursor to the first character of
the line it is on.
7. -'(Cursor Right). Moves the cur-
sor to the right one character
position.
8. ~ (Boundary Right). Moves the
cursor to the last character of
the line it is on.
9. FIND. Moves the cursor to the
next character or string of char-
acters that was selected.
10. GO TO. Moves the cursor to the
beginning of the selected page in
the document being created or
revised.
Chapter 2. Operating Instructions 2-7