Battery Test - Toshiba 1600EP Series Instruction Manual

Data Setting Screens (Cont'd)
the following screens show the setting procedure for setting the data variables. they are accessed from
the main Data Setting screens (see
to begin: Set
or

battery teSt

inhibit
Voltage aDJ: +5
to aCCept: Set
Voltage aDJ: +4
to aCCept: Set
Voltage aDJ: -5
to aCCept: Set
loops through
eleven possibilities
Clear timer Set
to aCCept: Set
DeFaUlt SettingS
to aCCept: Set
38
page 33) when the SHIFT/SELECT key is pressed:
Shift Set
battery teSt
+
Select monitor
executes battery test and returns
to Data Setting screens
Shift Set Voltage aDJ: +5
+
to Change:SeleCt
monitor
Select
Shift Set Voltage aDJ: +4
+
to Change:SeleCt
Select monitor
Shift Set
Voltage aDJ: -5
+
to Change:SeleCt
Select monitor
returns to Data Setting screens
(with new value applied)
Shift Set
Clear timer Set
+
to Change:SeleCt
Select monitor
executes battery test and returns
to Data Setting screens
Set
Shift DeFaUlt SettingS
+
to Change:SeleCt
monitor
Select
executes battery test and returns
to Data Setting screens
this parameter has no options to set.
a battery test will be performed once
###%
the ShiFt + Set button is pressed.
if the bat teSt inhibit message is
displayed, it indicates that a battery
test has been performed recently.
the UpS will not allow frequent bat-
tery tests to insure that the batteries
remain in a fully charged state.
this parameter allows the user to off-
set the output voltage (while the unit
is running on-lline) in 1% increments
over a range of +/-5% total offset.
Default value is 0%
this parameter has no options to set.
pressing the ShiFt + Set button
while this message is displayed will
cancel timer settings.
this parameter has no options to
set. pressing the ShiFt + Set but-
ton while this message is displayed
will reset all variables to their default
value.
1600ep Series instruction manual