Bosch CM10GD Operating/Safety Instructions Manual page 46

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 46
To operate in Bevel Range 3:
1. Move the left and right sliding fences out to
clear saw assembly and relock (see Figure
51).
2. Lift bevel lock lever above table height with
the left hand.
3. Grasp the main handle with the left hand
and tilt the saw assembly slightly to the left
while rotating the spring-loaded bevel range
selector knob with the right hand so the
knob's indicator points to the red square
below "Max. Bevel Angle to 47° Left or
Right."
4. Once in needed bevel position, hold saw
head by the right hand and use left hand to
press down the bevel lock lever below table
height.
NOTE: The selector knob will stay in this
"override" position. Turn the knob slightly
clockwise and it will snap back to bevel range
1 (default position).
Saw Operations
Figure 50
1
2
4
Figure 51
46
3