Installation - Haier HWF10DW1 User Manual

Installation

Preparation
Remove all packaging material including polystyrene
base. While opening the package, water drops may be
seen on plastic bag and porthol e. This is normal as a
result from water tests and quality control in the factory.
Note: Packaging disposal:
Keep all packaging material out of children's reach and
dispose them in an environmentally friendly manner.
Installing bottom plate
1. Lay the washing machine down to its side, window
upwards, bottom side towards operator. Insert the
bottom plate into the cabinet, then fixed with 2 screws
to the cabinet on the window side.
Removing the transportation bolts
The transportation bolts a re designed for clamping
antivibration components inside the appliance during
transportation.
2. Remove all 4 bolts.
General information and tips:
Keep the transportation bolts in a sa fe place for later
use. If the machine is to be moved to another location,
replace transportation bolts contrariwise to prevent
damage.
3. Fill the transportation bolt holes with blanking plugs.
6 7
4. Adjust all feets to achieve a complete level
position.This will minimize vibrations and noise
during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment. Floor
should be as stable and flat as possible.
Inlet hose
1. Connect inlet hose to the machines water inlet valve .
2. Connect inlet hose to a water tap.
3. Tighten inlet hose connections and turn on water
supply. Check for any water leaks. Stop all water
leaks before continuing with in stallation.
Warning!
Appliance is only qualified for cold water supply!
Drain hose
Drainage could be installed in dif ferent ways.
Nevertheless, level of drain hose has to reach between
80-100 cm.
If possible always keep drain hose fixed to the clip at
the back of the appliance.
1. Drain hose to sink
Use the drain hose bracket to keep drain hose end retai-
ned and out of any water level.
Fix the bracket securely to avoid dropping due to oper-
ational movements.
2. Drain hose to sink siphon
Connection has to be securely sealed and fixed to corr-
esponding adapter above the siphoning part!
Warning!
The drain hose should not be submerged in water and
should be securely fixed and leak-free. If the drain hose
is placed on the ground or if the pipe is at a height of
less than 80 cm, the washing machine will continuously
drain while being filled (self-siphoning).
Installation
80 - 100 cm