Installing A Memory Module - Toshiba Satellite R800 Series User Manual

■
Be careful not to let screws or other foreign matter fall into the
computer. It could cause malfunction or electric shock.
■
Additional memory module is a precision electronic component that
may be fatally damaged by static electricity. Since the human body can
carry static electricity, it is important that you discharge yourself before
touching or installing any additional memory modules. To discharge
your body's static electricity, simply touch any metal close to you with
bare hands.
Use a point size 1 Phillips screwdriver for R850/R840 and point size 0
Phillips screwdriver for R830 to remove and fasten the screws - the use of
an incorrect screwdriver can damage the screw heads.

Installing a memory module

To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
5. Loosen the screw(s) securing the memory module cover in place -
please note that the screw(s) are attached to the cover in order to
prevent them from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
1. Screws
User's Manual
Turning off the power
Figure 3-12 Removing the memory module cover (R830)
section in Chapter 1, Getting Started if
section in Chapter 5, Power and Power-Up
2. Memory module cover
3-39