NEC UNIVERGE SV8100 Manual page 16

SIP Trunk to Carrier
SIP Trunk to Carrier
SV8100 does NOT guarantee to work with any SIP Trunk Carrier eve
SV8100 does NOT guarantee to work with any SIP Trunk Carrier eve
SV8100 does NOT guarantee to work with any SIP Trunk Carrier even though the Carrier supports the
" Standard SIP " protocol. Connection test and evaluation are necessary before i
" Standard SIP " protocol. Connection test and evaluation are necessary before i
"Standard SIP" protocol. Connection test and evaluation are necessary before installing to the customer site.
Related Programming
Related Programming
After setup the basic setup for IP Trunk, the following related PRGs are set.
(Required PRG depends on the SIP Carrier.)
• PRG 10-12-06 : Assign "1 : Enable" or "0 : Disable" to use NAPT Router.
• PRG 10-28
• PRG 10-29
• PRG 10-30
© 2009 by NEC Taiwan
<Important Notice>
<Important Notice>
<Important Notice>
(Default : 0 <Disable>)
: Register the necessary basic information of SIP Trunk such
as Domain Name, Host Name, User ID and so on.
: Register the necessary information of SIP Server such as
Proxy IP Address & Port Number, DNS Server IP Address &
Port Number, and so on. This PRG is not required in case the
SIP Trunk is non-registration mode.
: Register the necessary information of SIP Authentication
information such as User Name, Password and so on.
n though the Carrier supports the
n though the Carrier supports the
nstalling to the customer site.
nstalling to the customer site.