Installation Instructions; Circuit Priming; Machine Connection - Saeco 10002671 Operating Instructions Manual

4 INSTALLATION
For your and other people safety, follow the "Safety
Regulations" in section 3 carefully.
4.1 Packaging
The original packaging has been designed to protect the
machine during transport. We recommend keeping the
packaging for future transport.
4.2

Installation Instructions

Before installing the machine, read the following safety
instructions carefully.
• Put the machine in a safe place.
• Make sure children cannot play with the machine.
• Do not place the machine on hot surfaces or near open
fl ames.
The coffee machine is now ready to be connected to the
power supply.
Note: it is recommended to wash the components
before using them for the fi rst time and/or after
they have not been used for a certain period of time.
4.3

Machine Connection

Electric power can be dangerous! It is therefore
essential to follow the safety regulations
carefully. Do not use faulty cords! Faulty cords and
plugs must be immediately replaced by authorized
service centres.
Appliance voltage has been pre-set by the manufacturer.
Make sure that the power voltage matches the indications
on the identifi cation plate on the bottom of the appliance.
• Make sure that the ON/OFF button (2) is not pressed
before connecting the machine to the power supply.
• Fit the plug into a wall socket with suitable power
voltage.
4.4 Water Tank
• (Fig.1) - Remove the water tank (3).
• (Fig.2) - Rinse the water tank and fi ll it with fresh drinking
water taking care not to overfi ll it.
• (Fig.1) - Reinsert the water tank into its seat and make
sure that it has been placed correctly.
Use only fresh, non-sparkling drinking water to
fi ll the tank. Hot water, as well as any other liquid,
may damage the tank. Do not turn on the machine with
empty water tank: make sure there is enough water in
the tank.
• 16 •
4.5

Circuit Priming

When the machine operates for the fi rst time and when
all the water has been dispensed, the machine circuit
needs priming. In this case, the 4 buttons of the control
panel will fl ash at the same time.
• (Fig.3) - Press the ON/OFF button (2). The 4 buttons will
fl ash.
• (Fig.4) - Place a container under the cappuccinatore.
• (Fig.5) - Open the "hot water/steam" knob (4) by turning
it anticlockwise.
• (Fig.6) - Press the hot water button (17).
• Wait for water dispensing to stop.
• Close the "hot water/steam" knob (4) by turning it
clockwise. Remove the container.
When the fi rst priming ends, the warming up
starts. Before brewing coffee, water and steam,
please wait for lights 15 and 16 to be permanently on.
The machine is now ready to brew coffee and dispense
steam. Please see related sections for operating details.
Note: if priming is not completed, the 4 buttons
will keep on fl ashing. The machine cannot be
used.
4.6 Drip Tray Adjustment
The drip tray can be adjusted according to the cup size.
To adjust the drip tray height, do as follows.
• (Fig.24) - Lift the drip tray and remove the grill.
• (Fig.25) - Remove the support under the drip tray.
• (Fig.26 - 27) - Rotate the support and place it in the coffee
machine.
• (Fig.28) - Put the drip tray on the support and replace the
grill.