Rear Panel - Philips VR388/55 User Manual

20 STOP 7 / ∞ ∞ ∞ ∞ ∞ button
• Stops the tape. ( P.14)
• Moves down the cursor when using
the menus. ( P.11)
21 CH (channel) 5 / ∞ button
Before using this button, press VCR or
TV.
• After pressing VCR, changes the
channels on the VCR. Release at a
desired channel.
For some Philips TV only:
• After pressing TV, changes the
channels on the TV. Release at a
desired channel.
22 VOL (volume) 5 5 5 5 5 / ∞ ∞ ∞ ∞ ∞ buttons
For some Philips TV only:
Changes the TV volume.
Release at desired volume.
23 CLEAR button
Erases unwanted timer programmes.
( P.18)
24 AUDIO/MUTE button
For some Philips TV only:
Turns off the TV sound.

Rear Panel

1
1 AC (alternating current)
power cord
Connect the AC power cord to an AC
outlet.
VR388/588-55 EN (N)
To insert the batteries:
1
Remove the battery compartment lid
from the bottom of the remote
control.
2
Install two batteries —R6(SUM-
3)/AA — matching polarity
indicated inside the battery
compartment.
3
Replace the lid.
ENTREE/SORTIE
AV1
IN/OUT
002
3
2 ANT. (antenna) IN (input)
terminal (from Antenna)
Connect your antenna or Cable to this
terminal. ( P.9)
— 7 —
7
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check "Specifications" to see what
other accessories are included.
CAUTION
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)
3 AV1 IN/OUT terminal
2
(SCART)
For connecting to the SCART terminal
(21-pin SCART connector) on TV or
another VCR. ( P.9. P.19.)
4 RF OUT (output) terminal (to
ENTREE
ANT.IN TV)
ANTENNE
Use the supplied RF coaxial cable to
SORTIE
RF. OUT
connect this terminal on the TV. ( P.9)
4
6/1/99, 9:01 AM