Scope Of Delivery; Installing The Appliance - Siemens KA N Series Installation Instructions And Instructions For Use

Don't
The product should not be opened by the user
■
himself/herself, but only by authorized service
personnel.
The product is not meant for re-sale to any
■
unauthorized agencies/scrap dealer/kabariwalah.
The product is not meant for mixing into
■
household waste stream.
Do not keep any replaced spare part(s) from the
■
product in exposed area.
3. Any disposal through unauthorized agencies/person
will attract action under Environment (Protection)
Act 1986.
Note
This product doesn´t use any hazardous -substances
as specified in the E-waste (Management) Rules 2016.

Scope of delivery

After unpacking all parts, check for any damage in
transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
customer service.
The delivery consists of the following parts:
Free-standing appliance
■
Bag containing installation materials
■
Interior fittings (depending on model)
■
Operating instructions
■
Customer service booklet
■
Warranty enclosure
■
Information on the energy consumption and noises
■

Installing the appliance

Transporting
The appliance is heavy. Secure in position during
transportation and installation.
Due to the weight/dimensions of the appliance and to
minimise the risk of injury and damage to the appliance
at least two persons are necessary to set-up the
appliance safely.
Installation location
Install the appliance in a dry, well ventilated room.
The installation location should neither be exposed
to direct sunlight nor near a heat source, e.g. a cooker,
radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances to a heat source:
3 cm to electric or gas cookers.
■
30 cm to an oil or coal-fired cooker.
■
If installing the appliance next to another refrigerator
or freezer, ensure a minimum lateral distance of 25 mm
to prevent the formation of condensation.
If a panel or cupboard is installed above the appliance,
ensure that a gap of 30 mm is left so that the appliance
can be pulled out of the recess if required.
The air heated on the rear side of the appliance must
be allowed to escape unhindered.
Subsurface
m
Caution
The appliance is very heavy.
Design: 109 kg
The floor of the installation location must not give way;
if required, reinforce floor.
To ensure that the doors can open all the way, observe
lateral minimum distances when installing
the appliance in a corner or recess (see chapter
Installation dimensions).
If the depth of the adjacent kitchen equipment is more
than 60 cm, observe lateral minimum distances
in order to utilise the full door opening angle (see
chapter "Door opening angle").
en
5