6.7.3 Installing the push bar
—
1. Place both clamping parts B on the ends of the backrest
tubes C. Make sure that the holes of the clamping parts
are aligned with the holes of the backrest tube ends.
2. Insert the push bar A into the backrest tubes.
3. Move the push bar to the required height (Pos. 1 –
5) and secure by turning the levers D of the clamping
part clockwise.
4. To remove the push bar reverse steps 3 to 1.
Adjusting the height
1. Loosen both clamping parts B by turning the levers D
counterclockwise.
2. Move the push bar A to the required height and secure
by turning the levers D of the clamping part clockwise.
6.7.4 Installing the Drip Stand
To install the drip stand the wheelchair has to be equipped with the push bar.
—
1650187-A
Instructions
■□□
■□□
25