Table of Contents
Advertisement
Invacare® Action® Ampla™
6.2 Push bar
A push bar can optionally be installed.
An installed push bar is required for the following options:
•
Assistant brake
•
Drip stand
Installing/removing
1. Place both clamping parts B on the ends of the backrest
tubes C. Make sure that the holes of the clamping parts
are aligned with the holes of the backrest tube ends.
2. Insert the push bar A into the backrest tubes.
3. Move the push bar to the required height and screw
the quick release pin E into the clamping part. Let the
pin engage to the nearest hole on the push bar.
28
4. Secure the push bar in the backrest tube on the other
side by turning the lever D of the clamping part
clockwise.
5. To remove the push bar reverse steps 3 to 1.
Adjusting the height
1. Loosen both clamping parts B by turning the lever D
counterclockwise and disengaging the quick release pin
E on the other side.
2. Move the push bar A to the required height and let
the quick release pin engage into the nearest hole of
the push bar.
3. Secure the push bar in the backrest tube on the other
side by turning the lever D of the clamping part
clockwise.
6.3 Drip stand
To install the drip stand the wheelchair has to be equipped
with the push bar.
1650186-A
Advertisement
Table of Contents
