Software Testing Procedures; Figure 27 System Table Editor Whs_R_Configuration Parameter - HP Indigo Press WS4000 Service Manual

HP Indigo press ws4000 Cluster 1 procedures
•2. In the Main Control Panel, click Options and Press Configuration. The
Press Configuration window opens.
•3. Go to the Mechanical Devices parameters.
•4. Ensure that the Ink Cabinet is set to Version 1.
•5. Ensure that the Inline Densitometer Cooling is Not installed.
•6. Go to the Web Handling parameters.
•7. Ensure that the Vacuum Box Type is set to Version 2.
•8. At the promt to Restart the press software, click OK.

Software testing procedures

Verify ILD firmware version
To verify the ILD firmware version:
•1. Open the press software System Table Editor (SysTab).
•2. Look for the ildPropertiesTopic in the tree.
•3. Look for the ildSoftwareVersion entry in the right pane of the window
For HP Indigo press w3200 look for the ildSoftwareVersion entry in the
right pane of the window of each slave tab.
The value in the Dynamic column should be X-Rite DTP24 vD303 for the
new ILD firmware. Old firmware version can be A210 or 9601.
WHS-software configuration check procedure
To verify whether the new software was installed, perform the following:

Figure 27 System table editor WHS_R_Configuration parameter

•1. In the software menus, go to the System Table Editor.
proprietary and confidential CA293-00600, Rev 00 page 37 of 221