Table of Contents
Advertisement
Then, read the section 'Preparation for use' in
the chapter 'Installing your video recorder'.
My screen is empty
Many TVs are switched to the programme num-
ber for the scart socket by way of a control signal
sent through the scart cable.
If the TV does not automatically switch to the scart
socket programme number, manually change to the
corresponding programme number on your TV (see
your TV's operating instructions).
Connecting without a scart cable
Have an aerial cable ready.
1.
1.
Switch off your TV.
2.
2.
Remove the aerial cable plug from the aerial
input socket of the TV. Insert it into the AERIAL
at the back of the video recorder.
3.
3.
Insert one end of the sup-
plied aerial cable into the
RF OUT at the back of the
video recorder and the
other end into the aerial
input socket at the back of
the TV.
4.
4.
Insert AC cable into the
wall socket.
5.
5.
Switch on your TV and
select the programme
number used for video playback on your TV.
(see your TV's operating instructions)
6.
6.
Start the TV's channel search manually as if
you wanted to save a new TV channel until
the next screen appears. (see your TV's oper-
ating instructions)
PLEASE CONNECT AERIAL OR
CABLE TO THE VCR
THEN...
PUSH P+ KEY
OR...
FOR PLAY ONLY-PUSH PLAY
I do not see the message screen
• Check the cable connections.
• Repeat the channel search on your TV.
7.
7.
Save this programme number setting on your
TV for video recorder operation.
Then, read the section 'Preparation for use' in
the chapter 'Installing your video recorder'.
Programme number for video recorder operation
You have now saved a programme number for
use by your video recorder as you would a reg-
ular TV channel. This programme number must
now be used in future for video recorder play-
back ('video recorder' TV channel).
5
AERIAL
TV
A E R I A
L
R F O U
T
TV
RF OUT
A E R I A
L
R F O U
T
EN
Advertisement
Table of Contents
