Table of Contents
Advertisement
Front of your VCR
To switch off or on, interrupt menu
STANDBY/ONy y
function.
PROGRAMME+
PROGRAMME-
programme number. During playback, press to adjust the
tracking.
To record the TV channel selected at this
RECORD
moment.
FWD.
When tape playback is stopped, press to fast
forward the tape at high speed. During playback, press to
fast forward the tape while the picture stays on the screen.
2. Important notes for operation
Navigation in the screen menu
You can check/change many functions and settings
of your video recorder via the on-screen menu. The
individual functions are selected, via the remote
control as follows:
Call up the menu: with
SELECT K L CHOOSE B
TIMER
RECORD SET UP
VCR SET UP
TUNER SET UP
INITIAL SET UP
END=EXIT
To select: with
PLAY B-K
To enter or change your selection: with the num-
ber buttons
or with
0..9
To save or confirm: with
To cancel: with
CLEAR
To end: with
STATUS/EXIT
Switching on
You can switch on the video recorder with the
Automatic switch-off
If the video recorder is not used for several minutes, it switches itself off automatically. This function can
be deactivated (e.g. if you want to use the video recorder as a TV receiver). For more information, please
read the section 'Automatic switch-off' in chapter 'Other functions'.
Time in the display
If you have switched the video recorder off with
'18:00'.
If the clock has not been set, ' --:-- ' will appear.
Power consumption
The video recorder should always be connected to the mains so as not to affect the use of the TV or
programmed recordings.
If the display has been switched off, your video recorder consumes less than 3W in stand-by.
Power outage/no power
Channel information remains saved for up to 1 year, the time and timer information is saved for up to 1
minute.
To select the
MENU
.
.
STOP C-L
PLAY B-K
STOP C-L
.
FWD
1- B
.
.
REW.
When tape playback is stopped, press to rewind the tape
at high speed. During playback, press to rewind the tape
while the picture stays on the screen.
PLAY
To play back a tape.
STOP/EJECT
cassette.
Back of your VCR
TV
To connect the TV.
AERIAL
To connect the aerial cable.
To connect the TV.
RF OUT
The symbols on your video recorder
display
These symbols can light up on your video recorder dis-
play:
When you keep your video recorder on.
When you have put a cassette in the video
recorder.
Display of programme number of the TV channel /
time / RF channel.
When you record.
When you have programmed a recording.
.
button.
STANDBY/ON y y
, the time will show in the display, e.g.
STANDBY/ON y y
3
To stop the tape and eject the
EN
Advertisement
Table of Contents
