Parameters Of The Ai 16 X 16 Bit; Table 10-13 Parameters Of Analog Input Module Ai 16 X 16 - Siemens SIMATIC ET 200PA SMART Operating Instructions Manual

ET 200PA SMART I/O modules
10.4 Analog input modules
10.4.3.1

Parameters of the AI 16 x 16 Bit

Parameter assignment
The parameters are assigned using the parameter assignment dialog of HW Config
Parameters of the AI 16 x 16 Bit
The table below provides an overview of the assignable parameters and their default settings
for the AI 16 x16 Bit.
The default settings apply when you have not assigned parameters in HW Config or you have
not changed any parameters.

Table 10-13 Parameters of analog input module AI 16 x 16

Parameter
Diagnostic interrupt enable
Diagnostics
● Group diagnostics analog
● Wire break check
Smoothing
Measurement type
Measuring range
Interference frequency sup‐
pression / integration time
* 4WMT = 4-wire transducer; 2WMT = 2-wire transducer
** Can only be set for 4-wire transducer
Group diagnostics analog
The diagnostics parameter "Group diagnostics" enables the signaling of channel-specific
errors to be switched off, with the exception of parameter assignment errors.
184
Value range
Yes / No
Yes / No
Yes / No
None
Weak
Medium
Strong
Disabled
4WMT current
*
2WMT current
*
Disabled
0 mA to 20 mA
**
4 mA to 20 mA
± 20 mA
**
60 Hz (16.6 ms)
50 Hz (20 ms);
10 Hz (100 ms);
Default setting
Yes
Yes
Yes
None
4WMT current
*
4 mA to 20 mA
50 Hz (20 ms)
Operating Instructions, 06/2019, A5E34192013-AB
Scope
Module
Channel
Channel
Channel
Module
Channel
Channel
ET 200PA SMART