Install Fan Tray - Cisco NCS 5500 Series Hardware Installation Manual

Install Fan Tray

Step 1
Unscrew the four captive screws on the front of the fan tray until each screw is free of the chassis (see the following
figure).
Figure 60: Remove Fan Tray from the Chassis
1 Unscrew four captive screws (two at the top of the
module and two at the bottom of the module).
2 Hold the two fan tray handles with your two hands.
Step 2 Hold both handles on the front of the fan tray with both of your hands and pull the fan tray out of the slot.
Step 3
Set the fan tray on antistatic material or inside an antistatic bag.
Install Fan Tray
Before you begin
• Fan tray slot is open in the chassis.
• Fan tray is available for installation.
Hardware Installation Guide for Cisco NCS 5500 Series Modular Routers
108
3 Pull on the fan tray to slide it out of the chassis. Set the
fan tray on an antistatic surface.
Replace Chassis Components