General Operations - Blaupunkt BPV 660 User Manual

General Operations

Turning the power On/Off
Press the PWR to turn the unit On or Off.
Volume Level Control and Memory
Rotate the VOL dial to adjust the volume.
It is also possible to set turn-on volume level by following the
procedure explained below.
1.
Rotate the VOL dial until it is set at the required volume.
Volume up
Volume down
2.
Press the PWR for two or more seconds. The power will
be switched off and the current volume level recorded.
Muting the sound
MUTE / SENS
Press .
The R-ch/L-ch Level Meter flashes.
MUTE / SENS
To restore the previous volume level, press
BPV660(EN)_body 3
Setting the Clock
The clock uses a 12-hour display system.
1.
Turn the ignition key to the ON position.
2.
Press the PWR to turn on the unit.
3.
Press and hold the DISPLAY for more than two seconds to
enter the Clock setting mode.
4.
Use the following buttons and dial to set the clock. (The blink-
ing section can be adjusted.)
: To activated Hour blink
AUDIO
: To activated Minute blink
MUTE / SENS
: Adjust the Hour and minute
5.
DISPLAY
Press the momentarily to complete the Clock set-
ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
again.
Press the DISPLAY while the ignition switch is in the " OFF "
position.
Display Priority Selector
Each time the DISPLAY is pressed, the display window will
change as shown below ;
• Radio mode
Frequency and Clock.
• CD / CDC(CD changer) mode
Elapsed time and Clock.
1/22/02, 10:48 AM
E-3