General Operations; Adjusting The Sound Characteristics; Display Selector; Setting The Clock - Blaupunkt RPD 540 Manual

Blaupunkt high-power fm/am/cd receiver with detachable face manual rpd 540
Table of Contents

Advertisement

Available languages

Available languages

General Operations

Power On/Off
Turning on the power
Press the
to turn on the unit.
PWR
Turning off the power
Press the
for more than 2 seconds.
PWR

Setting the Clock

The clock uses a 12-hour display system.
1.
Turn the ignition key to the ON position.
2.
Press the
to turn on the unit.
PWR
3.
Press the
and hold 2 seconds to start.
DISP
Use the following buttons to set the clock. (The blinking
section can be adjusted.)
/
: Adjust the Hour and minute
: To activate Hour blink
: To activate Minute blink
4.
Press the
to activate the clock.
DISP
Ignition-off Clock Call
The display will illuminate showing the time and then automati-
cally shut off after 5 seconds.
Briefly press the
while the ignition switch is in the " OFF "
DISP
position to activate.

Display Selector

Each time the
is pressed, the display window will change
DISP
as shown below;
• Radio mode
Frequency and Clock.
• CD mode
Elapsed track time and clock.
Volume Level Control
Press the
to adjust the volume level.
/
VOL
: Volume up
: Volume down.
You can check the volume level visually with the indicators in
the display window.
Volume level meter

Muting the Sound

Briefly press
while the receiver is on.
PWR
While muting the sound, the MUTE indicator
is blinking.
To restore the previous volume level, press
Loudness Effect
When listening to music at low volume levels, this feature will
boost the extremes of the bass and treble ranges to compen-
sate for the negative characteristics of human hearing.
Press the
.
LD/SENS
The "LD" indicator appears in the display window.
Pressing this button again will cancel this feature.

Adjusting the Sound Characteristics

1.
Press the
AUD
BASS
TREBLE
2.
Press the following buttons to adjust the selected item. Make
the adjustment within 5 seconds after selecting. After 5
seconds, the display window will revert to previous indica-
tion.
BASS
TREBLE
BALANCE
FADER
MUTE LEVEL
on the display
You can check the each level visually with the indicators in the
display window.
again.
PWR
to select the desired adjustment mode.
BALANCE & FADER
Mute level
Adjustment Range
/
BASS -7
BASS 7
/
/
TREB -7
TREB 7
/
L
9 (Full left)
9 (Full right)
R
R
9 (Full front)
9 (Full rear)
F
(-80)
(-0)
Center level mark
FADER
BALANCE
E-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents