Troubleshooting Guide; Specifications - Blaupunkt BPV 660 User Manual

Troubleshooting Guide

The following check will assist in the correction of most prob-
lems which you may encounter with your unit. Before going
through the check list below, refer back to the connection and
operating procedures.
General
Trouble Cause/Solution
Leads are not matched
• Memorized stations and
correctly with the car's
correct time are erased.
accessory power
• The fuse has blown.
connector.
• Radio works when the igni-
tion key is the ON, ACC and Check wiring for short
OFF positions. circuits.
• No power is being supplied
to the unit.
• The power is continuously The car doesn't have an
supplied to the unit. ACC position.
Radio reception
Trouble Cause/Solution
Preset stations are not re-
The broadcast signal is too
ceivable. weak.
Seek tuning is not possible The broadcast signal is too
weak. → Use manual tuning.
Travel Store feature does Not enough broadcast frequen-
not complete storing of six cies are receivable.
stations.
Also make sure that antenna is connected, extended and dry
inside.
If the above mentioned solutions do not help to improve the
situation, consult your nearest Blaupunkt dealer or in the
United States call 1-800-266-2528 for technical assistance,
parts and service. Call 1-800-950-2528 for dealer referral or
to request product brochure.
BPV660(EN)_body 11
CD Player Troubleshooting
When problems occur with CD playback, an error message
appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists, contact your
nearest Blaupunkt dealer.
Message Possible cause Recommended action
E-01 Dirty disc. Clean the disc.
Scratched disc. Replace the disc.
Up-side-down. Check the disc.
E-02 Focus error. Try ejecting and re-insert-
ing under normal tempera-
ture conditions.
E-03 Data and focus error. Under normal temperature
conditions, eject and insert
clean, undamaged disc
properly.
E-04 Mechanical problem. Eject and re-insert.
E-05 Loading/Eject error. Eject and re-insert.
CD Changer Troubleshooting
When problems should develop while operating CD changer,
an error message appears in the display window.
Refer to the table below to identify the problem, then take the
suggested corrective action. If the error persists or "E-03" and
"E-05" appears, contact your nearest Blaupunkt dealer.
Message Possible cause Recommended action
no dISC No magazine.
Load the magazine in
No disc.
no-d the CD changer.
Check the disc.
Up-side-down.
Check the disc.
E-01
Focus error.
Communication error. Check the connection of
E-02
the CD changer.
The error sign will go off
Excessive tempera-
E-04
and play will resume
ture conditions at
when the temperature to
the CD changer.
a normal range.

Specifications

GENERAL
: Approx. 178 mm × 50 mm × 155 mm
Dimensions
(W × H × D)
Power requirements : 12 volts DC car battery
(negative ground)
Output Power : RMS and Peak Power ratings (188
watts)
230 watts/57.5 peak × 4ch
Output Wiring : Floating-ground type designed for 4
speaker use.
RCA low-level outputs (2 channels).
Output Impedance : Compatible with 4-8 ohm speakers.
Low - Level Output : 2 V.
TUNER
Tuning Range : AM : 530 - 1,710 kHz (10 kHz step)
FM : 87.5 - 107.9 MHz (200 kHz step)
Sensitivity : AM : 20 µV
FM : 9.1 dBf mono sensitivity
FM
Stereo Separation : 35 dB
CD PLAYER
Frequency
Response : 20 - 20,000 Hz
S/N Ratio : 98 dB
Wow & Flutter : Below the measurable limit
OTHER
Remote Control Options: RC-823 Credit Card Remote
CD Changer Cable : p/n F00E500029
AUX Input Cable : p/n 7 607 897 093
1/22/02, 10:49 AM
E-11