Scanning Stations With Radio-Scan; Selecting The Seek Tuning Sensitivity; Switching From Stereo To Mono (Fm) - Blaupunkt BOLOGNA RCR 126 Operating Instructions Manual

Scanning stations with
Radio-Scan
Beginning with the station currently tuned in,
you can scan the waveband. The radio will
play each station for 8 seconds.
To start the scan:
• Press SC briefly.
The scanned frequency or the station
name will start flashing in the display.
During the actual scanning process
"SCAN" will be displayed.
To select a station currently being scan-
ned and switch off the scan function:
• Press SC briefly.
If no station is selected, the scan function will
be automatically switched off after the fre-
quency band has been run through comple-
tely. The unit will tune in the station listened
to before starting the scan.
28
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
If "lo" is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If "lo" does not light up, the radio will also pick
up weaker, distant stations (high sensitivity).
To switch over,
• Press lo or dx.
On top of this, the sensitivity levels can be
adjusted separately for lo and dx (see chap-
ter "DSC programming").
Switching from stereo to mono
(FM)
If reception is poor, you may get better sound
quality by switching to mono:
• Press the lo button for approximately 2
seconds.
With mono playback, the stereo sign
will disappear from the display.
Each time the radio is switched on, stereo
playback is activated.
The unit will automatically switch to mono if
the received signal is not strong enough for
stereo playback.