Selecting A Waveband; Automatic Tuning; Manual Tuning; Scrolling Through The Broadcasting Network (Only Fm) - Blaupunkt BOLOGNA RCR 126 Operating Instructions Manual

Radio / cassette
Table of Contents

Advertisement

take advantage of the full RDS service, switch
to "REG OFF".
Press the REG button briefly.
When active, "REG ON" will be briefly dis-
played each time the radio is switched on.

Selecting a waveband

With this car radio you can select between
the following wavebands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
Select the desired waveband by pres-
sing the FM
or M•L button.
T
To switch between MW and LW:
Press M•L.

Automatic tuning

/
Press
/ ; the car radio will automati-
cally search for the next station.
When keeping the upper or lower part / of
the rocker switch depressed, seek tuning will
speed up in upwards or downwards direc-
tion.
26
Automatic tuning
Up
Down
/
Up/down in short intervals
("AF" must be switched off)
/
To scroll through the broadcasting
network when "AF" is activated
(e.g. NDR1 ... NDR4).
Manual tuning << >>
(prerequisite: AF is switched off!)
Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.
When holding the right or left part of the
rocker switch pressed down, the frequency
scan is speeded up.
Scrolling through the broad-
casting network (only FM)
You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of one broadcasting
network can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g.
NDR 1, 2, 3, 4, N-JOY (North German broad-
caster).
For this it is necessary that the stations have
been received at least once and that "AF" has
been activated before (lights up in the dis-
play).
For this purpose, you may start Travelstore
seek operation:
Press FM
for 2 seconds; the system
T
starts to run through the frequency
band.
If "AF" does not light up,
press AF.
With this, the requirements for selecting sta-
tions with << >> are fulfilled.

Changing the memory bank (FM)

You can shift between the memory banks I, II
and T in order to store stations and recall
them later.
The currently selected memory bank is indi-
cated in the display.
Press the FM
button as many times
T
until the desired memory bank lights up
in the display.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rcr 45

Table of Contents