Table of Contents
Advertisement
Troubleshooting
WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If
you are unable to remedy a problem by following these hints, consult your dealer or
Philips for help.
Problem
Radio reception is poor.
"NO DISC" is displayed or the disc cannot
be played.
The system does not react when buttons are
pressed.
Sound cannot be heard or is of poor quality.
The remote control does not function
properly.
The timer is not working.
The system displays features automatically and
buttons start flashing.
Refer to the FAQ (Frequently Asked Questions) on the supplied CD-ROM or visit our website
26
✔ If the signal is too weak, adjust the antenna or connect
✔ Increase the distance between the system and your TV
✔ Insert a disc.
✔ Load in the disc with the labeled side facing up.
✔ Replace or clean the disc, see "Care and safety
✔ Use a finalised CD-R(W) or a correct format disc.
✔ Remove and reconnect the AC power cord and switch
✔ Adjust the volume.
✔ Disconnect the headphones.
✔ Check that the speakers are connected correctly.
✔ Check that the AC power cord is connected properly.
✔ Select the source (CD or TUNER, for example) before
✔ Reduce the distance between the remote control and
✔ Replace the battery.
✔ Point the remote control directly toward the IR sensor.
✔ Set the clock correctly.
✔ Press TIMER ON/OFF to switch on the timer.
✔ Press and hold DEMO STOP on the main unit to switch
"www.audio.philips.com" for latest update on FAQ.
Solution
an external antenna for better reception.
or VCR.
information".
on the system again.
pressing the function button (É Å, S , T).
the system.
off the demonstration mode.
Advertisement
Table of Contents
