Table of Contents
Advertisement
46 Sound (Analog Output)
If you used the red and white AUDIO OUT jacks on the back of
the DVD Player to connect to a Stereo Receiver, you need to
choose a setting for Analog Output. First, make sure you used the
red and white jacks, not the COAXIAL or OPT OUT Digital
Audio Out jacks.
Then, check your Stereo Receiver and see if it is compatible with
Dolby Surround or TruSurround. Then follow the steps below to
choose the Analog Output setting that is most compatible with
your audio equipment.
1
Press SYSTEM MENU.
2
Press p repeatedly to select
3
Press p to select Analog output, then press B.
4
Press o or p to select Stereo, Dolby Surround, or 3D
sound, then press the OK button.
Select Stereo if your audio equipment is not compatible with
either Dolby Surround or TruSurround.
Select Dolby Surround if your audio equipment is compatible
with Dolby Surround. If it is, usually a Dolby Surround logo
will appear on the equipment.
Select 3D Sound if the audio equipment is TruSurround com-
patible. Again, the audio equipment likely will be labelled with
the TruSurround logo.
Z
Y
1en
1en
Digital output
Analog output
s p Stereo
G
Night mode
5
Press SYSTEM MENU to remove the menus.
will be selected.
G
, then press B.
d
1
2
Dolby Surround
3D Sound
1,5
2-4
Advertisement
Table of Contents
