Connecting To A Tv Only - Philips DVD870PH98 Owner's Manual

10 Hookups (cont'd)
1
Connect the Pr/Cr Pb/Cb Y VIDEO OUT jacks on the
DVD Player to the corresponding Pr/Cr Pb/Cb Y VIDEO
IN jacks on the TV. Use a Pr/Cr Pb/Cb Y cable (not supplied).
2
Connect the supplied red and white audio cables to one
set of the Left and Right AUDIO OUT jacks on the DVD
Player. Connect the other end of the cables to the
left/right AUDIO IN jacks on the TV. Match the cable colors
to the jack colors.
3
Connect the power cords of the DVD Player and the TV
to the power outlet. Turn on the power of the TV and the
DVD Player.
4
Set the TV to the correct Component Video In channel.
Such channels may be called AUX or AUXILIARY IN,
AUDIO/VIDEO or A/V IN, EXT1 or EXT2, etc. These channels
often are near channel 00. See your TV owner's manual for
details. Or, continue to change channels at the TV until you
see the DVD Player's screen saver on the TV screen.

Connecting to a TV Only

TV has Component Video In Jacks
2
DIGITAL AUDIO OUT
PCM-MPEG2-Dolby Digital-DTS
COAXIAL OPT OUT SUB WF OUT
RIGHT AUDIO IN
Y
LEFT AUDIO IN
Pb/Cb
Pr/Cr
1 1
L L
2 2
P /C P /C Y
R L (CVBS) R R B B
AUDIO OUT VIDEO OUT VIDEO OUT S-VIDEO OUT
• Your TV may have a different
jack panel than the one shown.
You will only need the jacks
shown on this page for this
hookup.
Back of TV
(example only)
RIGHT AUDIO IN Y
LEFT AUDIO IN Cb/B-Y
Cr/R-Y
1
(Y/C)
Helpful Hint