Table of Contents
Advertisement
6
en | Safety
Always use Teflon tape and sealant on connector threads of any mount (sold separately by
Bosch or user-supplied).
1.5
Connection in applications
24 VAC power source: This unit is intended to operate with a limited power source. The unit
is intended to operate at 24 VAC (if PoE+ is not available). User supplied wiring must be in
compliance with electrical codes (Class 2 power levels).
PoE: Use only approved PoE+ devices. Power-over-Ethernet can be connected at the same
time as a 24 VAC power supply.
If auxiliary power (24 VAC) and PoE+ are applied simultaneously, the camera selects auxiliary
input and shuts off PoE+.
1.6
Important notices
Indoor use only (NDP-5512-Z30C) - The product shall only be used indoors. Ethernet network
should be connected to a network environment, which must comply with the following
conditions:
1.1 The function of the ITE being investigated to IEC 60950-1 is considered not likely to
require connection to an Ethernet network with outside plant routing, including a campus
environment.
1.2 The ITE is to be connected only to PoE networks without routing to the outside plant.
Notice!
This is a class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
1.
2.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
–
–
–
–
2019-03 | 1.2 |
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
–
This device may not cause harmful interference.
–
This device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Installation Manual
AUTODOME IP starlight 5000i
Bosch Security Systems
Advertisement
Table of Contents
