confirmed on the product. Contact your local Husqvarna representative if the same message appears
often. For more information, refer to
Message
Cause
No loop signal
The power supply or the voltage cable
are not connected.
The power supply or low voltage cable
are damaged.
The boundary wire is not connected to
the charging station.
The boundary wire is broken.
ECO mode is activated and the prod-
uct has attempted to start outside the
charging station.
The pairing between the product and
the charging station is lost.
The boundary wire is crossed on its
way to and from an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles.
Wheel motor
Grass or other object has wrapped
blocked
around the drive wheel.
Wheel drive prob-
lem
42 - Troubleshooting
Messages on page 31 .
Action
Examine the LED status on the charg-
ing station. If the LED is not lit, it indi-
cates that there is no power. Examine
the wall socket connection and whether
an earth-fault breaker has tripped.
Make sure that the low voltage cable is
connected to the charging station.
Replace the power supply or low volt-
age cable.
Make sure that the boundary wire con-
nectors are fitted properly to the charg-
ing station. Replace connectors if dam-
To install the charging
aged. Refer to
station on page 22 .
Check the signal given by the LED on
the charging station. If the LED indi-
cates break in the boundary wire, find
out where the break is. Replace the
damaged section of the loop with a new
loop wire and splice using an original
Find breaks in the
coupler. Refer to
loop wire on page 51 .
Put the product in the charging station.
Start the product and close the hatch.
Put the product in the charging station
and generate a new loop signal. Refer
To create a New loop signal on page
to
31 .
Make sure that the boundary wire is in-
stalled correctly. Refer to
boundary wire on page 23 .
Move the boundary wire and/or make
more islands in the work area to in-
crease the signal strength.
Examine the drive wheel and remove
the grass or other object.
1427 - 002 - 20.12.2019
To install the