Husqvarna AUTOMOWER 535 AWD Operator's Manual page 23

guide wire is complete. Refer to
the boundary wire on page 23 and To
install the guide wire on page 23 .
8. Attach the charging station to the ground
with the supplied screws after the guide wire
To install the guide wire
is installed. Refer to
on page 23 .
3.5.3 To install the boundary wire
CAUTION: Do not put unwanted wire
in a coil. The coil causes interference
with the product.
1. Put the boundary wire around all of the work
area. Start and complete the installation
behind the charging station.
2. Open the connector and put the boundary
wire in the connector.
3. Close the connector with a pair of pliers.
4. Cut the boundary wire 1-2 cm / 0.4-0.8 in.
above each connector.
5. Put the right end of boundary wire into the
channel with the mark "AR".
6. Put the left end of boundary wire into the
channel with the mark "AL".
7. Push the right connector onto the metal pin
on the charging station with the mark "AR".
8. Push the left connector onto the metal pin
on the charging station with the mark "AL".
9. Put the cable mark on the left and right
boundary wire. Do not walk on the charging
station.
1427 - 002 - 20.12.2019
To install
3.5.4 To install the guide wire
1. Open the connector and put the wires in the
connector.
2. Close the connector with a pair of pliers.
3. Cut the guide wires 1-2 cm / 0.4-0.8 in.
above each connector.
4. Put the guide wires centrally below the
charging station plate, and push them
through the slot in the charging station
tower.
5. Push the connector onto the metal pin on
the charging station with the mark "G1, G2"
or "G3".
6. Disconnect the charging station from the
power outlet.
7. Put the cable mark on the guide wires.
8. Put the end of the guide wires at the eyelet
on the boundary wire.
9. Cut the boundary wire with a pair of wire
cutters.
10. Connect the guide wires to the boundary
wire with a coupler.
a)
CAUTION: Twinned cables, or a screw
terminal block that is insulated with
insulation tape are not satisfactory
splices. Soil moisture will cause the
wire to oxidize and after a time result in
a broken circuit.
Put the 2 ends of the boundary wire
and the end of the guide wires into the
coupler.
Installation - 23